MHSC WR2500X02 Manuel du propriétaire télécharger pdf (Page 6)

Windsor High Efficiency Wood Insert

30005129

ST1024

faceplate assy

10/08

Figure 5

Face Plate Assembly

ST1024

34

FACEPLATEINSTALL



Masonry

Fireplace

End of

Spring

Spring #10

Face Plate

Assembly

ST1025

Figure 6

Install Face Plate







1. A chimney connector shall not pass through an attic,

roof space, closet, floor, ceiling or similar concealed

space. Where passage through a wall or partition of

combustible constructions is desired, the installation

shall conform to CAN/CSA B365 (in Canada). In the

US, check with local building officials for require-

ments in your area.

2. It is advisable to have your masonry chimney in-

spected for deterioration such as cracks and crum-

bling mortar before you install your unit.

34

CHIMNEYLINER



6” (152 mm) Min.

Dia. Stainless

Steel Flexible

Liner

 A stain-

less steel adapter

is recommended for

fastening the stainless

steel flexible liner to

the collar.

Male or crimped end

of the adapter must

be installed inside the

flue collar. Drill flue

collar to permanently

fasten stainless steel

adapter using a mini-

mum of 3 screws.

Fasten stainless steel

chimney liner to the

stainless steel adapter

using manufactures

instructions.

ST1026

Figure 7

Chimney Liner

3. To help ensure a good draft, the top of the chimney

should be at least 3 feet (914 mm) above the point

of penetration through the roof, and be at least 2 feet

(610 mm) higher than any point of the roof within 10

feet (3 m).

4. Do not use makeshift compromises during installa-

tion.

5. Do not remove bricks or mortar from the fireplace.

Canada: This fireplace insert must be installed with

a continuous chimney liner of 6” (152 mm) minimum

diameter extending form the flue collar to the top of the

chimney. The chimney liner must conform to the class 3

requirements of CAN/ULC-S635 Standard for lining sys-

tems for existing masonry or factory-built chimneys and

vents, or CAN/ULC-S640 Standard for lining systems

for new masonry chimneys. (Fig. 7)

USA: This fireplace insert must be connected to:

1. A chimney complying with the requirements for type

HT chimneys in the Standard for Chimneys, Factory-

built, Residential type and building Heating Appli-

ance, UL103, or

2. A code-approved masonry chimney with flue liner.





Contact your local building authority for approved meth-

ods of installation.

 This fireplace insert must be connected to:

A chimney complying with the requirements for type

HT chimneys in the Standard for Chimneys, Factory-

built, Residential Type and building Heating Appliance,

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

MHSC WR2500X02 Manuel du propriétaire Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Foyers MHSC WR2500X02